Home 

Ref-Wiki.com -

Technical information Air-Conditioning Basic Air Conditioning Operation
There should be freedom of the air circulation under the block suppresses the formation of rust due to block permanently wet. Pair 4″ x4″ timbers would raise the condenser from the earth is rather high for ventilation to take place.

The air handler (evaporator section), you can in many places, depending on the structure. In the residence of the air handling can be installed in a garage, interior closet, or in the attic. In direct cool device or heat pump air contains a fan, the spring, and controls. If the air conditioning system was added after the heating system was installed, the Plenum of metal, usually above the furnace heat exchanger. Coil and froze deBVice is in the Plenum. Fan furnace is used for air-conditioning unit. The controls are mounted in the furnace section. This can be either a gas or oil furnace.

There should be breathing air to get back to the unit. If the evaporator section in closet, louvered doors, sufficient for the passage of air back to the unit. If the evaporator plot is in the garage or attic, recirculated air grill.com/img_article/fire-stat.JPG" alt="fire-stat" width="342" height="422" />

the switch also provides a manual reset.

The detectors can be installed on ventilation fans to stop their operation with the smoke is detected. Fig. 18-2 shows this type of smoke detector.

smoke-detector

....
 
Thanks ->



Approach temperature Carbon steel pipe fitting Condenser Capacity Contact freezing Copper pipe sizes inches to mm Finned tube evaporator Forced draft cooling tower Gas furnace operation High side of a refrigeration system Oil separator in refrigeration cycle Refrigeration cycle Setting epr valve Static condenser
Copyright @ 2009 - 2022, "www.ref-wiki.com"